Continuous Flow Verification

  Enquire / contact me

In process analyzer sampling systems

Test & Measurement

Continuous Flow Verification
Continuous Flow Verification

With FM and FMc approvals, the FS10A Analyzer Flow Switch/Monitor from Fluid Components is suitable for continuous flow verification applications that support process analyzer sampling systems operating in hazardous plant areas in the United States (U.S.), Canada and elsewhere worldwide. The FM and FMc approvals are as follows: Nonincendive, Class I, Division 2 Groups A, B, C, D; Class II, Division 2 Groups E, F, G; Class III T4@Ta=71ºC Type 4X. The FM and FMc approvals specify design criteria for flow meters and other electrically-powered instruments for use in areas where combustible gases may be present. These approvals assure the instrument has been designed and tested to operate safely in these hazardous conditions. It is a small, lightweight instrument featuring low flow sensitivity, a relay alarm trip point, an analog output and an RS232 interface. The device's electronics and thermal dispersion flow sensing technology provide a superior overall solution to sampling system flow assurance. It is suited for continuous monitoring of analyzer sample flows to provide the highest integrity process analysis without interruption.

Posted on September 12, 2012 - (656 views)
by
Fluid Components International
1755 La Costa Meadows Drive
92078 San Marcos - USA
+1-760-7446950
+1-760-7366250
View full company profile
Location
Related articles
3D Optical Scanner
Bi-Metal Temperature Gauges
Microscope Optics by Optris Presented at SPS IPC Drives
Labfacility L60+ Thermocouple & Fine Wire Welder
Verigo Model PB3 Reusable Temperature Data Logger
Ultrasonic Flowmeter for Laboratory
Ultrasonic Flowmeters for Compressed Air
Temperature Control Technology
Monitoring receiver
IPLEX G Lite