Flow Meter

  Enquire / contact me

meets international safety standards

Test & Measurement

Flow Meter
Flow Meter

Fluid Components International launched its ST75 flow meter, designed for process gas, fuel gas, inert gas, waste gases and air in small line sizes ranging from 0.25 to 2.0 inches. This flow meter is FM and CSA approved and is therefore suited for usage in rugged process and industry environments. It meets international safety standards for loss protection and risk management. The flow meter provides the following 3 outputs:  the mass flow rate, totalized flow and media temperature.  Its precision flow element has a no-moving parts design that employs platinum RTD sensors embedded in equal mass thermowells with microprocessor electronics calibrated to laboratory standards for a wide range of gases: natural gas, methane, nitrogen CO2, argon, all inert gases and compressed air.

Edited by: Filip Burm

Posted on November 17, 2010 - (1342 views)
Fluid Components International
1755 La Costa Meadows Drive
92078 San Marcos - USA
+1-760-7446950
+1-760-7366250
View full company profile
Location
Related articles
3D Optical Scanner
Bi-Metal Temperature Gauges
Microscope Optics by Optris Presented at SPS IPC Drives
Labfacility L60+ Thermocouple & Fine Wire Welder
Verigo Model PB3 Reusable Temperature Data Logger
Ultrasonic Flowmeter for Laboratory
Ultrasonic Flowmeters for Compressed Air
Temperature Control Technology
Monitoring receiver
IPLEX G Lite